Yesterday and today, I made the first parts on my lathe. A bit of relief and variation in between the sanding, which is still
not entirely done. I made the bushings from 7075-T6 which I had in stock. I had to get very thin boring bars, but maybe I should
just have bought some larger drills. As so often... I just wanted to learn and give it a try. This tiny boring bar was screeching
like hell and had some serious chatter, but: it worked, and on shorter lengths it probably works really well.
Once large enough, the 6 mm boring bar with carbide insert worked smoothly. I opened up the bore to 17.8 mm and then reamed it to 18 mm H7
by hand. I only took photos of the first bushing I reamed, with the four-jaw chuck clamped on the table. Later, I just used the chuck on the lathe
and locked it against rotation, which worked a lot better.
The marked bar stock for the next bushing in the lathe. Started taking photos at the second bushing.
×
The marked bar stock for the next bushing in the lathe. Started taking photos at the second bushing.
OD already turned. Grooves are done and the mini boring bar (4mm!) mounted.
×
OD already turned. Grooves are done and the mini boring bar (4mm!) mounted.
Switched to a larger, stiffer boring bar.
×
Switched to a larger, stiffer boring bar.
Measuring the ID with a telescopic gauge. Didn't know these existed until recently, now I don't want to miss them anymore.
×
Measuring the ID with a telescopic gauge. Didn't know these existed until recently, now I don't want to miss them anymore.
Reaming the bore to H7 by hand, with the bushing held in the four-jaw chuck.
×
Reaming the bore to H7 by hand, with the bushing held in the four-jaw chuck.
Checking the reamed bore with a telescoping gauge.
×
Checking the reamed bore with a telescoping gauge.
Reading the telescoping gauge with a micrometer.
×
Reading the telescoping gauge with a micrometer.
The micrometer reading: the bore is within tolerance.
×
The micrometer reading: the bore is within tolerance.
All four wing pin bushings finished. The glue grooves on the outside give the adhesive something to key into.
×
All four wing pin bushings finished. The glue grooves on the outside give the adhesive something to key into.
Bores reamed to H7.
×
Bores reamed to H7.
Side Project: 3D Printing the Wheel Assembly
As a side project, I started 3D printing the wheel assembly. That's because I have ordered the rims. It is not exactly what I will use
in the end, but it was fun to sketch the parts up in FreeCad and get it printed.