Sanding the fuselage frame
Continued sanding the fuselage frame... it takes time... almost meditative.
×
The fuselage frame after the sanding session, looking aft.
×
Bulkhead sanded flush with the longerons.
×
Glue squeeze-out removed and the edges sanded smooth.
×
Bulkhead flank blended into the longeron at the notch.
×
Rasps and files do most of the work in the tight corners.
×
Bulkhead-to-longeron joint after cleanup.
×
Another joint after cleanup; the glue fillet stays in place.
×
The C10c cutout with its rounded, laminated edge.
×
Close-up of the rounded edge after sanding.
Wing pin bushings
To have something else to do, I started machining the bushings for the wing pins. First parts on the lathe! I am excited! I didn't get far though, I only managed to face off one end and center drill it... it's a start!
×
7075 bar in the lathe, center-drilling the end face.
×
Center drill engaged in the faced-off end of the bar.